LOW COST

The abrasive water jet machining center uses your existing DXF files (or other CAD drawings). No costly dies, fixtures, or elaborate CNC programming required.

NO MINIMUM

Low startup costs allow for inexpensive, highly accurate production for quantities as small as one item.

FAST TURNAROUND

Working from your drawings eliminates the need to wait for dies or fixtures.

HIGHLY PRECISE

Cuts are accurate within ±0.005.

SMOOTH, FLAT CUTS.

Water jet cuts are very smooth, similar to a fine sandblasted finish. Flexible materials cut with less taper than cuts made through die cutting.

NO HEAT BUILD UP

Because there is no heat build up aterials like glass, rubber, and plastic will not melt during the cutting process. This relieves structure changes.

CUTS JUST ABOUT ANYTHING

Jet machining is capable of cutting just about anything.

LESS WASTE

Reduction of scraps because of the Part Nesting feature.

ENVIRONMENTALLY FRIENDLY

Water is used instead of other gases, liquids and oils in the process of machining products.